Description
This document describes how a Condition Affecting the Network form must be compiled, issued, cancelled, fulfilled and managed.
Not what you are looking for? See more Procedures
Introduction
NRF 004 Condition Affecting the Network (CAN) is used to record reports about conditions that can or do affect the safety of operations in the Network.
The CAN Form is also used by Signallers to give written warning to Drivers and Track Vehicle Operators as specified in the Network Rules.
Numbering forms
The Signallers issuing a CAN Form must number the form consecutively on a pad-by-pad basis.
Mandatory item
The following items must be completed:
1 CAN Number
Optional items
The following items are optional:
2 Report details
3 CAN block working
4 Active control level crossing
5 CAN restrain details
6 Special instructions and additional information
7 Issued by
8 Issued to
Review each item, and:
- put a cross in the numbered box
if the item does not apply in this instance, or - tick the numbered box
if the item applies in this instance and complete the details.
Item 2 – Report details
If the item applies, tick the numbered box 
and record the details about the CAN report.
Item 3 – CAN block working
If the item applies, tick the numbered box
and review each part of item 3.
Block Posts
If block post locations have not been established, put a cross in the check box .
If block post locations have been established, tick the check box and complete the details.
Warning signs
If warning signs have not been used, put a cross in the check box .
If warning signs have been used, tick the check box and complete the details.
Signals at STOP
If authorisation is not given to pass signals at STOP, put a cross in the check box .
If permission is given to pass signals at STOP without further authorisation:
- tick the check box , and
- detail the signals. The signals must not include signals used as a block post location, and
- give full details of the first operating signal to be obeyed.
Item 4 – Active control level crossings
If the item applies, tick the numbered box 
and complete the details.
Item 5 – CAN restraint details
If the item applies, tick the numbered box 
and record the details about the CAN restraint requirements.
When the CAN restraint is ended, tick the check box and complete the details.
Item 6 – Special Instructions and additional information
If the item applies, tick the numbered box 
and record information about special instructions or additional information, such as:
- WOLO speed restrictions
- other speed restrictions
- location of Qualified Workers
the length and location of disabled rail traffic.
Item 7 – Issued by
If the item applies, tick the numbered box 
and complete the details.
Item 8 – Issued to
If the item applies, tick the numbered box 
and complete the details.
